1. Should the soil for raising snails be loose or tight?It is best to use moist, loose, humus-rich soil for snails, and to prevent the soil from hardening, it is best to replace it once every six months or a year. 2. Methods and techniques for breeding land snails?1. Suitable environment. In the process of raising snails, mix leaf mold, peat soil and fine sand to prepare the soil, and place the breeding container in a cool and ventilated place, keep the temperature at around 23 degrees, and the air humidity at 60 to 70 percent. Pay attention to the snails raised in the open air, and take shading measures for them. 2. Feeding. Snails are omnivorous and partial eaters. During the breeding process, they can be fed with various vegetable leaves, fruit peels, wheat flour, white beans and other foods, and the types of food should be changed regularly. Do not feed a single food to avoid poor growth of snails. In addition, irritating foods should not be fed to snails. 3. Daily maintenance. When raising snails, you must ensure that the breeding environment is clean and sanitary to prevent bacteria from growing, which is not conducive to the growth and health of the snails. Usually, you should clean the box every three to four days to remove food residues, snail feces, etc. in the box. Note that leaves and branches need to be placed in the box to provide a place for the snails to crawl and play. 3. What are the requirements for snail breeding sites?Soil environment: Snails like to burrow into humus soil to live and lay eggs, so it is recommended to use nutrient soil rich in humus. Temperature conditions: The suitable temperature conditions for snail farming are between 16-30 degrees Celsius, avoiding temperatures above 40 degrees Celsius or below 5 degrees Celsius. Moist and dark: Snails hide during the day and come out at night. They are afraid of direct sunlight, so a moist breeding environment is required. 4. How to keep snails alive longer?1. Temperature: The cultivation temperature should be controlled between 16 and 40°C; 2. Soil: The breeding soil should be moist and fluffy humus soil; 3. Light: Snails are shade-loving animals and do not need sunlight. During the breeding season, you can give snails some scattered light to stimulate egg laying. 4. Humidity: The relative humidity of the air in the breeding environment should be between 80% and 90%; 5. Feeding: Feed the snail one to two pieces of vegetable leaves every day. 5. Can I only put sand when raising snails?Instead of putting sand, put soil in the box. Spread a layer of sterilized breeding soil in the box. This soil can be some soil dug from the vegetable field. Spread the soil on the bottom of the box. Don't spread too much. The height is about one-fourth of the box. Because snails like to live in a humid environment, the breeding soil must be kept moist and not too dry. Therefore, you can spray some water on the soil according to the dryness of the soil. 6. Can peat soil be used to raise snails?Snails give birth to their babies in the soil. There are many fungi rich in humus in the soil, and snails need them. Quote: Snails like to live in dark and humid environments with weeds, lush crops, soft soil, and more humus. They hide during the day and move at night. Sometimes they come out during the day to feed on rainy days. 7. Do I need to change the soil for raising white jade snails frequently?To raise white jade snails, you need to use loose, moist, humus-rich soil, and replace it every six months or a year to avoid the soil from becoming compacted and hardened. When breeding, you can also mix farmland soil, sandy soil, yellow sand, cinder ash, and stone powder in a ratio of 3:2:1:5:0.5 to make breeding soil, then expose it to the sun for several days for disinfection, and then add an appropriate amount of water to make the soil humidity reach 40%. Snails have strong survival ability and are tolerant to cold, heat, drought, and hunger. At the same time, they also have a wide range of diets. They can feed on various weeds, vegetables, melon and fruit peels, and can also feed on the stems, leaves, flowers, and fruits of crops. 8. How to choose and process the soil for snail breeding?Snails, like other terrestrial mollusks, have the habit of living, laying eggs and hatching in the soil. They are also soil animals and like to eat humus and suck water in the soil, especially young snails. Therefore, when breeding snails artificially, the disinfection and laying thickness of the soil for snail breeding are particularly important. Disinfection of breeding soil (1) High temperature treatment ① Sunlight disinfection: Place the prepared breeding soil on a clean cement floor, wooden board, iron sheet or plastic film, spread a thin layer, and expose it to the sun for 3 to 15 days to kill a large number of pathogen spores, hyphae, pest eggs, pests, nematodes, etc. ②Steam sterilization: There are two methods: steam sterilization and sterilization cabinet sterilization. Steaming sterilization: Put the breeding soil in the steamer and heat it to 60-100℃ for 30-60 minutes. Disinfection in a disinfection cabinet: Convert a large gasoline barrel or box with a lid into a steam disinfection cabinet, insert a pipe through its wall, and connect it to a steam furnace (heating boiler, etc.). Then put the breeding soil into the cabinet (barrel), open the air inlet valve, and let the steam enter the gap between the soil layers (be careful not to seal the lid too tightly to prevent explosion). After 30 minutes, most bacteria, fungi, nematodes and insects can be killed, and most weed seeds can lose their vitality. ③Boiling disinfection: Pour the breeding soil into the pot, add water and boil for 30 to 60 minutes, then filter out the water and let it dry until the temperature reaches a suitable level. ④Boiling water disinfection: Pour the breeding soil into an iron bucket, fill it with 100℃ boiling water until the soil is submerged, then cover and seal it overnight to kill ants, centipedes, eggs of miscellaneous insects, germs in the soil, and destroy residual pesticides. The next day, pour out the soil in the bucket, filter the water, crush it, dry it, and place it in the breeding box or pool. ⑤ Fire burning (frying) disinfection: Put the breeding soil in an iron pot or iron plate and burn it with fire. After the soil particles become dry, burn it for another 0.5 to 2 hours. This can completely kill the bacteria and pests in the soil. (2) Chemical treatment ①Formaldehyde (Formalin): There are 3 treatment methods. Treatment 1: Sprinkle 40% formaldehyde (400-500 ml) diluted with 50 times water evenly on each square meter of the breeding soil, then pile up the soil, cover with plastic film, and seal for 24-48 hours. Remove the covering, spread the soil, and wait until the formaldehyde gas is completely volatilized. Treatment 2: Spray the breeding soil with 0.5% formaldehyde, mix well and pile it up, seal it with plastic film for 5 to 7 days, then peel off the film to allow the smell of the medicine to evaporate. Treatment 3: Sand and gravel breeding soil can be directly soaked in 50-100 times formaldehyde solution for 2-4 hours. After draining the liquid, rinse it with clean water 2-3 times. ②Sulfur powder: There are 2 processing methods. Treatment 1: Apply 80-90 grams of sulfur powder per square meter of breeding soil and mix well. Treatment 2: Sprinkle 25-30 grams per square meter on the plowed land and turn the land to kill the bacteria. ③ Lime powder: Use lime powder to disinfect the breeding soil, which can kill insects and sterilize, and also neutralize the acidity of the soil. There are two treatment methods. Treatment 1: Apply 90-120 grams of lime powder per square meter of breeding soil and mix thoroughly. Treatment 2: Sprinkle lime powder at a dosage of 30 to 40 grams per square meter on the plowed land for disinfection. ④ Carbendazim: Apply 40g of 50% carbendazim powder per square meter of breeding soil, mix well and cover with film for 2 to 3 days. After removing the film, wait for the smell of the medicine to evaporate. ⑤ Mancozeb: Apply 60g of 65% Mancozeb powder per square meter of breeding soil, mix well and cover with plastic film for 2 to 3 days. After removing the film, wait for the smell of the medicine to evaporate. ⑥ Chloropicrin: stack the breeding soil or substrate layer by layer, 20 to 30 cm per layer, evenly spread 50 ml of chloropicrin per square meter per layer, and stack up to 3 to 4 layers. After quickly stacking, cover with plastic film and seal. Keep it for 10 days when the temperature is above 20℃, and keep it for 15 days when the temperature is above 15℃, then remove the film and turn it over several times to fully disperse the chloropicrin. ⑦N-methylnaphthalene and methylamine mixture: Apply 5% N-methylnaphthalene and methylamine, 6% snail ester, 5% diazinon and 3% marathon mixture to the breeding soil and mix well. It can kill ants, centipedes, ground beetles, burying beetles and mold in the soil. ⑧Phoxim: When underground pests in the soil of the snail breeding area are seriously harmful, you can use 0.1 kg of 50% phoxim and add 10 kg of bait to make poison bait, and spread it on the breeding ground to lure and kill the snails. ⑨ Trichlorfon: When underground pests in the soil of the snail breeding area are seriously harmful, you can use 0.5 kg of 90% trichlorfon crystals and add 50 kg of bait to make poison bait, and spread it on the breeding ground to lure and kill the snails. ⑩Others: Lime chloride, methyl bromide, benomyl, etc. can also be used for soil disinfection. Note: Wear a mask and gloves when performing drug disinfection to prevent the drug from being inhaled into the mouth and contacting the skin. Rinse your mouth after work and wash your hands and face carefully with soap. (3) Equipment processing ① Microwave disinfection machine: Use a microwave disinfection machine consisting of a 30-kilowatt high-wave radiation device and a microwave radiation plate to disinfect the breeding soil. ② Flame soil disinfection machine: This machine uses gasoline as fuel to heat the soil, which can make the soil temperature reach 79-87°C, which can kill various pathogenic microorganisms and pests. |
<<: CATDOLL: What are the dangers of keeping spiders to humans?
1. Perch: What is the connection between cod, per...
1. How often should earthworms be added to one ac...
Generally speaking, it is recommended to feed cat...
1. Is cockroach farming a scam? It's not a sc...
1. What is the market status of cockroach breedin...
What is foot-and-mouth disease in goats Goat foot...
1. Methods of catching river crabs 1. Lower the w...
1. How should turbot breeding and management be c...
1. How do sea cucumbers grow their internal organ...
1. How to breed red worms? Feeding red worms Spec...
1. Why are there so many little frogs on the stre...
1. How to raise ants? Artificial breeding method ...
What kind of insect is the hornet? Insects. 1. Wa...
During the epidemic period, chicken diseases have...
How much is 3-4 kg silver carp? The purchase pric...