CATDOLL : CATDOLL: How to purify and breed guppies? Please give the answer to the detailed process! !

1. How to purify and breed guppies? Please give the answer to the detailed process! !

Purify...

Purebred peacocks of the parent generation → peacocks of the next generation → grow up → remove those with impure colors and separate the males and females → the next round of reproduction

Avoid inbreeding

Purebred males are more rare than females. Even if all the parents are purebred, the pure male peacocks of the next generation are still rare. This is why purebred peacocks are more expensive in the market.

2. How to make a delivery room for guppies

Method of making the delivery room for guppy fish:

1. Find a beverage bottle with a large diameter, divide the bottle into two parts, with the upper part being shorter, and thread a string through the cut to make it easier to take.

2. Make holes in two parts of the bottle body. The holes are to allow air to flow through the mother fish and the small fish. The amount of air flow should not be too large so that the small fish cannot get stuck and swim out.

3. Tie the gauze net tightly at the mouth of the bottle. Make sure it is tied tightly. The mesh of the gauze net should not be too small, 2~3mm is appropriate. The fish will sink to the bottom of the water after birth, so it can escape from the mesh.

4. Insert the bottle mouth downwards into the bottle body and place it in the fish tank.

5. When the mother fish shows signs of giving birth, put the mother fish into the bottle. After the mother fish gives birth, the small fish will fall from the net into the outer bottle and will not be eaten by other fish.

3. How to make a breeding box for guppies? Please explain the process clearly. I need it urgently. Thank you!

Take a small container and poke many small holes in the bottom for the baby fish to pass through.

In fact, you don't need to go through so much trouble. Just isolate the mother fish that have given birth and raise them separately. The mother fish will not eat her own babies. I have observed for many years and I guarantee that they will not eat them.

4. About the feeding and breeding of guppies and how to raise them after breeding

When guppies lay small fish, they should be separated from other big fish. After separation, it is best to wait for the big fish to lay down. Take out one small fish at a time and put it in a less transparent container (plastic basin, porcelain basin) to avoid the small fish from being hurt. The big fish and the small fish cannot be put in the same container at the same time, otherwise the tragedy of the big fish eating the small fish will occur. If you have any questions, please contact Q942963655 Ahao

5. What materials do you use to make your own breeding box for guppies? Please provide detailed pictures of the process.

Mineral water bottle: cut the upper part of the bottle, remove the bottle cap, put the upper part into the lower part of the bottle, put it into the tank and fix it, and it's done. (This is how I used to raise peacocks. It's simple, practical and economical)

6. How to raise tropical fish guppies

Pro Tip:

How to take care of newborn fish:

The temperature should be kept at around 28 degrees.

Water change: If the fish tank has a filter, change the water once every three days, and change one-third each time. If it is a small fish tank (if the tank is too small, be careful not to increase the stocking density), then change it once a day, and change about one-fifth. It should be noted that the temperature of the new water should be kept consistent with the water temperature in the original tank as much as possible, and the difference should not be too large. It is best to be within plus or minus 0.5 degrees, because the small fish are too fragile at this time. When changing the water, do not let the impact of the water flow be too strong. Another thing to note is that you must not use freshly connected tap water for replacement. Newly connected tap water contains a lot of substances that are harmful to fish, so the newly connected water must be left for two or three days before changing the water for the small fish.

Feeding: Go to the fish market and buy very thin nematodes. Small fish cannot swallow such a long nematode, so you need to cut the long nematode into small pieces of about 0.2 cm in length by hand or other tools. This will make it easy for small fish to eat. If it is really not possible, you can feed some raw egg green (but feeding raw egg green will seriously pollute the water quality, so you need to change the water in time).

If you still don't understand, please send me a message and I will reply as soon as possible.